MBK 40 & daytona
-
- Technicien
- Messages : 818
- Inscription : dim. 09 déc. 2007 - 12:54
Tu cherches quoi comme taille de pipe d'admission ? J'en ai ou je peux en avoir. Il suffit de la retailler un peu à l'intérieur, mais le diamètre extérieur est nickel.
http://www.bibliotobec.org Tobec forever !
SP98 Motoconfort (1967) : viewtopic.php?t=21098
SP98 Motobécane Rats Racer "The Holy Grail" (1967) : viewtopic.php?t=22043
99Z Motobécane (1976)
AV78 Motobécane (la 1ère bleue)
P'tet un nouveau bitza sur base 89 ^^
SP98 Motoconfort (1967) : viewtopic.php?t=21098
SP98 Motobécane Rats Racer "The Holy Grail" (1967) : viewtopic.php?t=22043
99Z Motobécane (1976)
AV78 Motobécane (la 1ère bleue)
P'tet un nouveau bitza sur base 89 ^^
-
- Apprenti
- Messages : 627
- Inscription : ven. 12 janv. 2007 - 15:10
Et attention aux couples de serrage, c'est du 5mm la vis de pipe
En moto faut pas tomber.... ca sert à rien.
http://ds44.free.fr/ventilxp/calculettes.htm
http://ds44.free.fr/mobyx/restauration_mobyx.htm
Récapitulatif des tutos : http://ds44.free.fr/ventilxp/tutos.htm
Mobyx X7AVL amélioré : AV10, Malossi G1R, 19 PHBG, culasse Malossi, poulie variatrice RGD (moteur fixe), vario RGD Titane
http://ds44.free.fr/ventilxp/calculettes.htm
http://ds44.free.fr/mobyx/restauration_mobyx.htm
Récapitulatif des tutos : http://ds44.free.fr/ventilxp/tutos.htm
Mobyx X7AVL amélioré : AV10, Malossi G1R, 19 PHBG, culasse Malossi, poulie variatrice RGD (moteur fixe), vario RGD Titane