salut, voila j'ai pas d'étincelle en sorti de ma bougie avec un multimètre j'ai mesuré jusqu'a la sortit du relais, mais je n'arrive pas a tester la bobine HT, j'ai trouver un post de gurtner qui testait la bobine avec un ohmètre
viewtopic.php?t=1961&postdays=0&postord ... ge&start=0
j'aurai donc voulu savoir si le test est le meme!!
je trouve donc:
-entre les deux bornes: 0.3ohm
-entre la masse et le fils HT: 5000ohm
est-ce normale!!!!
Bobine HT!!
Bobine HT!!
MBK 51:
-moteur liquide [origine]
-allumage electro + kick (enfin)
-carbu 15 SHA
-pot popy gold
-moteur liquide [origine]
-allumage electro + kick (enfin)
-carbu 15 SHA
-pot popy gold
Si tu as fait la mesure au bout du fil HT (le bout qui se met dans l'antiparasite), ça peut être normal, les 5kΩ faisant office d'antiparasite.
En moto faut pas tomber.... ca sert à rien.
http://ds44.free.fr/ventilxp/calculettes.htm
http://ds44.free.fr/mobyx/restauration_mobyx.htm
Récapitulatif des tutos : http://ds44.free.fr/ventilxp/tutos.htm
Mobyx X7AVL amélioré : AV10, Malossi G1R, 19 PHBG, culasse Malossi, poulie variatrice RGD (moteur fixe), vario RGD Titane
![Image](http://img294.imageshack.us/img294/2347/trt1rx7.gif)
![Image](http://www.toutelatele.com/IMG/arton783.jpg)
http://ds44.free.fr/ventilxp/calculettes.htm
http://ds44.free.fr/mobyx/restauration_mobyx.htm
Récapitulatif des tutos : http://ds44.free.fr/ventilxp/tutos.htm
Mobyx X7AVL amélioré : AV10, Malossi G1R, 19 PHBG, culasse Malossi, poulie variatrice RGD (moteur fixe), vario RGD Titane
![Image](http://img294.imageshack.us/img294/2347/trt1rx7.gif)
![Image](http://www.toutelatele.com/IMG/arton783.jpg)